From 08/2009

METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: ON-VEHICLE INSPECTION

1. INSPECT SPEEDOMETER

(a) Check speedometer operation.

(1) Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.

Reference: mph (for U.S.A.)





Reference: km/h (for Canada)





Reference: km/h (except Canada)





NOTICE:
Tire wear as well as over or under inflation will cause errors.

(2) Check the deviation of the speedometer indication from the acceptable range.

Reference:

Less than 0.5 km/h (0.3 mph)

HINT
If the indication is not as specified, go to Problem Symptoms Table Problem Symptoms Table.

2. INSPECT HEAD-UP DISPLAY (COMBINATION METER MIRROR ECU)

HINT
When the head-up display (combination meter mirror ECU) position or illuminance has not adjusted properly, head-up display (combination meter mirror ECU) may not be seen in the front glass. Before starting following inspection, confirm the head-up display (combination meter mirror ECU) position and illuminance.

(a) Turn the power switch off.

(b) Turn the power switch on (IG) while pressing and holding the head-up display (combination meter mirror ECU) on switch.

(c) Keep pressing the head-up display (combination meter mirror ECU) on switch and turn the power switch off.

(d) Keep pressing the head-up display (combination meter mirror ECU) on switch and turn the power switch on (IG).

(e) The head-up display (combination meter mirror ECU) will show "TEST MODE".

(f) Inspect the head-up display (combination meter mirror ECU) as shown in the illustration.





(g) Turn the power switch off to finish test mode.