From 08/2009

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER

(a) Connect the connector.





(b) Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning receiver.





(c) Install the bolt.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedures from "Install roof headlining assembly" Installation.

3. INSPECT TIRE PRESSURE WARNING SYSTEM

(a) Inspect the tire pressure warning system Test Mode Procedure.