Up to 08/2009

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/o Side Monitor System): HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use the following procedure to troubleshoot the rear view monitor system.
* *: w/ Navigation System (for HDD) Only
1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage with the power switch off.

Standard Voltage:

11 to 14 V

(a) If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

NEXT -- Continue to next step.

3. CUSTOMER PROBLEM ANALYSIS

Result





B -- Go to step 5
A -- Continue to next step.

4. CHECK AND CLEAR DTCs*

(a) Refer to DTC check/clear Navigation System (for HDD).

NEXT -- Continue to next step.

5. PROBLEM SYMPTOM CONFIRMATION

Result





B -- Go to step 7
A -- Continue to next step.

6. SYMPTOM SIMULATION

Result





B -- Go to step 9
A -- Continue to next step.

7. CHECK DTC*

Result





B -- Go to step 10
A -- Continue to next step.

8. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM (for HDD)*

(a) Refer to the navigation system (for HDD) How to Proceed With Troubleshooting.

Result





B -- GO TO NAVIGATION SYSTEM (FOLLOW NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)
A -- Continue to next step.

9. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result





B -- Go to step 11
A -- Continue to next step.

10. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

(a) Terminals of ECU Rear View Monitor System (w/o Side Monitor System)

NEXT -- Continue to next step.

11. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

12. CONFIRMATION TEST

NEXT -- END