Up to 08/2009

AUDIO / VIDEO: REAR SEAT ENTERTAINMENT SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use the following procedure to troubleshoot the rear seat entertainment system.
* *: Use the Techstream.
1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

(a) Inspect the battery voltage.

Standard Voltage:

11 to 14 V

(a) If the voltage is below 11 V, recharge or replace the battery before proceeding to next step.

NEXT -- Continue to next step.

3. CHECK FOR DTC*

(a) Refer to DTC Check / Clear Reading and Clearing Diagnostic Trouble Codes.

Result:





HINT
If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the Techstream Reading and Clearing Diagnostic Trouble Codes.

B -- Go to step 7
A -- Continue to next step.

4. DTC CLEAR*

(a) Clear the DTCs and finish diagnostic mode.

HINT
The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

NEXT -- Continue to next step.

5. RECHECK FOR DTC*

(a) Recheck for DTCs.

Result:





HINT
* Even if the malfunction symptom cannot be confirmed, check for DTCs. This is because the system stores history DTCs.
* If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the Techstream Reading and Clearing Diagnostic Trouble Codes.
* Check the DTC and inspect the area the code indicates.
B -- Go to step 7
A -- Continue to next step.

6. DIAGNOSTIC TROUBLE CODE CHART

(a) Find the output code in the diagnostic trouble code chart Rear Seat Entertainment System.

NEXT -- Go to step 9

7. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result:





HINT
If the symptom does not recur and no DTC is output, perform the symptom simulation method How To Proceed With Troubleshooting.

B -- Go to step 9
A -- Continue to next step.

8. CHECK ECU TERMINAL ARRANGEMENT BASED ON MALFUNCTION SYMPTOM

(a) Refer to Terminals of ECU Pinout Values and Diagnostic Parameters.

NEXT -- Continue to next step.

9. CHECK CIRCUIT

(a) Adjust, repair or replace as necessary.

NEXT -- Continue to next step.

10. RECHECK FOR DIAGNOSTIC TROUBLE CODE*

HINT
After clearing the DTCs, recheck for DTCs.

NEXT -- Continue to next step.

11. PERFORM CONFIRMATION TEST

NEXT -- END