From 08/2009

AUDIO / VIDEO: RADIO RECEIVER: INSTALLATION

1. INSTALL RADIO RECEIVER ASSEMBLY

2. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Engage the 5 claws to install the No. 4 instrument panel register assembly.





3. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Engage the 5 claws to install the No. 3 instrument panel register assembly.





4. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY Installation

5. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER

(a) Connect each connector.

(b) Engage the 9 clips.





(c) Install the radio receiver assembly with register with the 4 bolts.

Torque : 4.9 Nm (50 kgf-cm, 43 in-lbf)

6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

7. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

9. INSTALL NO. 1 SWITCH HOLE BASE Installation

10. INSTALL INSTRUMENT PANEL GARNISH LH Installation

11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

14. INSTALL REAR DECK FLOOR BOX (w/ Navigation System for HDD) Installation

15. INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

(a) Inspect the suspension control system Test Mode Procedure.