From 08/2009

HYBRID / BATTERY CONTROL: CIRCUIT BREAKER SENSOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE ENGINE ROOM SIDE COVER LH Removal

3. REMOVE ENGINE ROOM SIDE COVER Removal

4. REMOVE COOL AIR INTAKE DUCT SEAL Removal

5. REMOVE INTAKE AIR RESONATOR SUB-ASSEMBLY Removal

6. REMOVE INLET NO. 2 AIR CLEANER Removal

7. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

8. SEPARATE VACUUM SWITCHING VALVE

(a) Disconnect the connector and hose.





(b) Remove the bolt, and separate the vacuum switching valve.

9. REMOVE NO. 1 CIRCUIT BREAKER SENSOR

(a) Move the outer section to the wire harness side as illustrated, then disconnect the No. 1 circuit breaker sensor connector.





Text in Illustration





(b) Remove the 2 bolts and No. 1 circuit breaker sensor from the inverter with converter assembly.