From 08/2009
POWER ASSIST SYSTEMS: DC / DC CONVERTER: REMOVAL
CAUTION:
Be sure to read Precaution thoroughly before servicing Hybrid Control System: Precaution.
1. PRECAUTION
Power Steering System
2. REMOVE SERVICE PLUG GRIP
HINT
Refer to the instructions for Removal of the service plug grips Removal.
3. REMOVE FRONT SEAT ASSEMBLY LH
HINT
Refer to the instructions for Removal of the front seat assembly Removal.
4. REMOVE FRONT SEAT ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal
7. REMOVE NO. 2 CONSOLE BOX DUCT Removal
8. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY Removal
9. REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Removal
10. REMOVE REAR CONSOLE BOX ASSEMBLY Removal
11. REMOVE FRONT DOOR SCUFF PLATE LH Removal
12. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal
13. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
14. REMOVE INSTRUMENT PANEL GARNISH LH Removal
15. REMOVE NO. 1 SWITCH HOLE BASE Removal
16. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal
17. REMOVE INSTRUMENT PANEL FINISH PANEL Removal
18. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL Removal
19. REMOVE CONSOLE BOX Removal
20. REMOVE FRONT DOOR SCUFF PLATE RH Removal
21. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH Removal
22. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
23. REMOVE INSTRUMENT PANEL GARNISH RH Removal
24. REMOVE REAR DOOR SCUFF PLATE LH Removal
25. REMOVE LOWER CENTER PILLAR GARNISH LH Removal
26. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Removal
27. REMOVE REAR DOOR SCUFF PLATE RH Removal
28. REMOVE LOWER CENTER PILLAR GARNISH RH Removal
29. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Removal
30. REMOVE NO. 1 POWER STEERING BRACKET
(a) Turn back the floor carpet until the power steering converter assembly can be seen.
(b) Remove the wire harness clamp from the No. 1 power steering bracket.
(c) Remove the 3 nuts and No. 1 power steering bracket.
31. REMOVE POWER STEERING CONVERTER ASSEMBLY (w/o Active Stabilizer System)
CAUTION:
Wear insulated gloves during this procedure.
(a) Disconnect each connector and remove the bolt and 2 clamps from the power steering converter assembly.
Text in Illustration
CAUTION:
* Wear insulated gloves during this procedure.
* Wrap insulating tape around the terminals of the removed high-voltage cables and connectors to insulate them.
(b) Remove the 3 bolts and power steering converter assembly from the vehicle.
32. REMOVE POWER STEERING CONVERTER ASSEMBLY (w/ Active Stabilizer System)
CAUTION:
Wear insulated gloves during this procedure.
(a) Disconnect each connector and remove the bolt and 2 clamps from the power steering converter assembly.
Text in Illustration
CAUTION:
* Wear insulated gloves during this procedure.
* Wrap insulating tape around the terminals of the removed high-voltage cables and connectors to insulate them.
(b) Remove the 3 bolts and power steering converter assembly from the vehicle.
