Continuously Variable Transmission/Transaxle: Testing and Inspection

P313 HYBRID TRANSMISSION / TRANSAXLE: HYBRID TRANSAXLE SYSTEM: ON-VEHICLE INSPECTION

1. INSPECT TRANSAXLE FLUID PRESSURE IN OIL PUMP

NOTICE:
Do the test at normal operating fluid temperature 50 to 80°C (122 to 176°F).

(a) Lift up the vehicle.

(b) Remove the fluid pump cover plug and O-ring.





(c) Install an oil pressure gauge with the adapter.

(d) Set the vehicle to FWD inspection mode Component Tests and General Diagnostics.

(e) Measure the fluid pressure.

Fluid pressure:

9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more

NOTICE:
Be sure to cancel the inspection mode immediately after the fluid pressure check is completed Component Tests and General Diagnostics.

(f) Install a new O-ring and the fluid pump cover plug.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)