Compressor Lock Sensor Circuit - Air Conditioning System

HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM: B1422/22: Compressor Lock Sensor Circuit
B1422/22 - Compressor Lock Sensor Circuit

SYSTEM DESCRIPTION

The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication.

The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier assembly determines that the cooler compressor assembly is locked and turns the magnet clutch assembly off.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Before performing the inspection, check that there are no problems related to the CAN communication system.

HINT
As DTC B1422/22 is also output when the compressor drive belt is damaged or loose, inspect the belt before performing troubleshooting.

PROCEDURE

1. INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)

(a) Remove the cooler compressor assembly (A/C lock sensor) Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR) Removal
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - A/C LOCK SENSOR)

(a) Disconnect the G13 amplifier connector.

(b) Disconnect the C32 sensor connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Result





B -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal

C -- REPAIR OR REPLACE HARNESS OR CONNECTOR

A -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures