Installation
INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (w/ Refrigerated Cool Box): INSTALLATION
1. INSTALL CONSOLE BOX RETAINER
(a) Install the console box retainer with 4 screws.
2. INSTALL COOLING BOX ASSEMBLY
(a) Connect the connector and install the console box assembly.
(b) Sufficiently apply compressor oil to 2 new O-rings.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the 2 O-rings to the 2 cooler pipes.
(d) Connect the 2 cooler pipes with the 2 bolts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(e) Connect the drain hose.
(f) Install the 8 bolts.
3. INSTALL CENTER FLOOR CARPET COVER RH
(a) Attach the 3 claws to install the center floor carpet cover RH.
4. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY Installation
5. INSTALL COOLING BOX TRAY
(a) Install the cooling box tray.
6. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
11. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
12. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
13. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
14. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
15. INSTALL FRONT SEAT ASSEMBLY RH
(a) Install the front seat assembly RH Installation.
16. CHARGE REFRIGERANT Service and Repair
17. WARM UP ENGINE Service and Repair
18. CHECK FOR REFRIGERANT GAS LEAK Service and Repair