Power Source Circuit
SEAT: REAR POWER SEAT CONTROL SYSTEM: Power Source Circuit
- Power Source Circuit
DESCRIPTION
Power is supplied to the fold seat control ECU through the ECU-B, FOLD SEAT LH*1, FOLD SEAT RH*2 and ECU-IG NO. 2 fuses.
* *1: for LH Side
* *2: for RH Side
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - BATTERY AND BODY GROUND)
(a) for LH Side:
Disconnect the d1 and d2 ECU connectors.
(b) for RH Side:
Disconnect the c1 and c2 ECU connectors.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for LH Side
for RH Side
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LH Side
for RH Side
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Rear Power Seat Control System