Cruise Main Indicator Light Circuit

CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: Cruise Main Indicator Light Circuit
- Cruise Main Indicator Light Circuit

DESCRIPTION

When the cruise control switch is on, the cruise control indicator light and RADAR READY indicator turn on. These indicators indicate the control condition (the presence or absence of a vehicle in front, vehicle-to-vehicle distance and set vehicle speed) and fail-safe state through the CAN communication system. When there is a malfunction, the master warning light and cruise control indicator light turn on and vehicle-to-vehicle distance information is displayed on the combination meter assembly as the alarm buzzer sounds. Items such as "CLEAN RADAR SENSOR", "CRUISE CONTROL NOT AVAILABLE", "CHECK CRUISE CONTROL SYSTEM" and "RADAR READY" are displayed on the multi-information display in the combination meter assembly when the ECM detects signals from each sensor and actuator and sends them to the combination meter assembly via the CAN.

HINT
* If the vehicle in front in the same lane significantly decreases in speed or another vehicle moves in front of your vehicle, adequate deceleration cannot be applied and the vehicle-to-vehicle distance shortens. At this time, the system sounds the buzzer to warn the driver.
* Each indicator in the dynamic radar cruise control uses CAN communication. Therefore, if there are any malfunctions in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

NOTICE:
When the ECM is replaced with a new one, initialization must be performed Programming and Relearning.

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)

(a) Select the item below in the Active Test, and then check that the cruise control indicator light illuminates Dynamic Radar Cruise Control System.

Combination Meter





OK:

Cruise control indicator light turns on/off.

NG -- GO TO METER / GAUGE SYSTEM Problem Symptoms Table
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)

(a) Use the Data List to check if the cruise control switch is functioning properly Dynamic Radar Cruise Control System.

Radar Cruise





OK:

On screen, item changes between ON and OFF according to above chart.

NG -- REPLACE ECM Removal

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Dynamic Radar Cruise Control System