ECU Power Source Circuit
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: ECU Power Source Circuit
- ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the driving support ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU - BATTERY AND BODY GROUND)
NOTICE:
A DTC is stored when the following inspection is performed. Be sure to clear the DTC after performing this inspection.
(a) Disconnect the G43 driving support ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Dynamic Radar Cruise Control System