Timing Cover: Specifications

Timing Chain Cover

(a) Align the oil pump drive rotor spline and crankshaft as shown in the illustration and install the chain cover.





(b) Temporarily install the 26 bolts and nut.





Standard Bolt:





NOTICE:
Make sure that there is no oil on the bolt threads.

(c) Tighten the 3 bolts in several steps in the sequence shown in the illustration.





Torque : 47 Nm (479 kgf-cm, 35 ft-lbf)

(d) Temporarily install the fan bracket with the 5 bolts.





Standard Bolt:





Text in Illustration





(e) Temporarily install the belt tensioner with the bolt and 6 mm hexagon bolt.





Text in Illustration





(f) Tighten the 8 bolts labeled 4 to 11 in several steps in the sequence shown in the illustration.





Torque : 47 Nm (479 kgf-cm, 35 ft-lbf)

(g) Tighten the 22 bolts and nut labeled 12 to 34 in several steps in the sequence shown in the illustration.





Torque : 23 Nm (235 kgf-cm, 17 ft-lbf)

NOTICE:
Do not start the engine for at least 2 hours after the installation.

NOTICE:
After the installation, if the seal packing has seeped out at the areas labeled A shown in the illustration, wipe it off.





Text in Illustration





(h) Check the torque of each bolt and nut again.