Operation CHARM: Car repair manuals for everyone.

Part 1





1UR-FE ENGINE CONTROL: SFI SYSTEM: DATA LIST / ACTIVE TEST

1. DATA LIST

HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
* In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
* The actual values may differ from the values listed in the chart under "Results of real-vehicle check" due to climate, weather conditions, etc.

HINT
Normal Condition: If no conditions are specifically stated for "idling", the shift lever should be in N or P, the A/C switch should be off and all accessory switches should be off.

(a) Warm up the engine.

(b) Turn the A/C switch off.

(c) Turn the engine switch off.

(d) Connect the Techstream to the DLC3.

(e) Turn the engine switch on (IG).

(f) Turn the Techstream on.

(g) Enter the following menus: Powertrain / Engine and ECT / Data List.

(h) According to the display on the Techstream, read the Data List.

2. Various Vehicle Conditions 1

Vehicle Speed





Engine Speed





Calculate Load





Vehicle Load





MAF





Atmosphere Pressure





MAP





Coolant Temp





Intake Air





Ambient Temperature





Engine Run Time





Initial Engine Coolant Temp





Initial Intake Air Temp





Battery Voltage