Removal

VF4BM TRANSFER / 4WD / AWD: 4WD CONTROL ECU: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH Removal

3. REMOVE COWL SIDE TRIM BOARD RH Removal

4. REMOVE INSTRUMENT SIDE PANEL RH Removal

5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

7. REMOVE LOWER INSTRUMENT COVER LH Removal

8. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Removal

9. REMOVE INSTRUMENT PANEL BOX DOOR COVER Removal

10. REMOVE INSTRUMENT PANEL BOX ASSEMBLY Removal

11. REMOVE 4 WHEEL DRIVE CONTROL ECU NO.2





(a) Disconnect the 2 connectors.

(b) Remove the bolt and four wheel drive control ECU.