Removal

STEERING COLUMN: DRIVING SUPPORT SWITCH CONTROL ECU: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH Removal

3. REMOVE COWL SIDE TRIM BOARD RH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

6. REMOVE INSTRUMENT LOWER COVER LH Removal

7. REMOVE NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY Removal

8. REMOVE INSTRUMENT SIDE PANEL RH Removal

9. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

10. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

11. REMOVE INSTRUMENT PANEL BOX DOOR COVER Removal

12. REMOVE INSTRUMENT PANEL BOX ASSEMBLY Removal

13. REMOVE DRIVING SUPPORT SWITCH CONTROL ECU

(a) Disconnect the connector.

(b) Remove the bolt and driving support switch control ECU.