Headlamp Alignment Sensor: Testing and Inspection

LIGHTING (EXT): HEIGHT CONTROL SENSOR: INSPECTION

1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH





Text in Illustration





(a) Connect 3 dry batteries of 1.5 V in series.

(b) Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NOTICE:
Do not apply a voltage of 5 V or higher.

If the result is not as specified, replace the rear height control sensor sub-assembly RH.