Installation

WIPER / WASHER: RAIN SENSOR: INSTALLATION

1. INSTALL RAIN SENSOR TAPE

NOTICE:
The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

(a) Clean the rain sensor sensing portion with a piece of cloth, etc.

(b) Peel off the smaller release sheet, and then attach the rain sensor tape on the rain sensor sensing portion as shown in the illustration.





Standard:





Text in Illustration





NOTICE:
Use your fingers to push out any air bubbles from under the tape.

2. INSTALL RAIN SENSOR

(a) Clean the windshield glass with a piece of cloth, etc.

NOTICE:
* Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.
* If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

(b) When installing a new rain sensor or replacing the rain sensor tape:

(1) Peel off the release sheet.

HINT
Do not touch the silicon coated surfaces.

(2) Attach the 2 guides, and then carefully install the rain sensor to the glass surface so that there are no air bubbles from forming between the contact surfaces.





Text in Illustration





NOTICE:
Do not touch the silicon coated or glass surfaces.

(3) Push in the stopper.

(4) Connect the connector.

3. INSTALL RAIN SENSOR COVER

(a) Attach the 2 claws to install the rain sensor cover.