Removal

AUDIO / VIDEO: RADIO RECEIVER: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE REAR DECK FLOOR BOX (w/ Navigation System for HDD) Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

6. REMOVE INSTRUMENT PANEL GARNISH LH Removal

7. REMOVE NO. 1 SWITCH HOLE BASE Removal

8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

9. REMOVE INSTRUMENT PANEL FINISH PANEL Removal

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL Removal

11. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER

NOTICE:
* The 4 bolts of the radio receiver assembly with register are installed though the service holes at the bottom in the instrument panel. Make sure to check all of them.
* If the radio receiver assembly with register is pulled without removing the 4 bolts, it may result in damage to the radio receiver assembly with register.

(a) Remove the 4 bolts.





(b) Disengage the 9 clips.

(c) Disconnect each connector and remove the radio receiver assembly with register.

12. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY Removal

13. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Disengage the 5 claws and remove the No. 3 instrument panel register assembly.





14. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Disengage the 5 claws and remove the No. 4 instrument panel register assembly.





15. REMOVE RADIO RECEIVER ASSEMBLY