Installation

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: INSTALLATION

1. INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY

(a) Install the sliding roof housing sub-assembly with the 8 bolts and 8 nuts.





Nut - Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

Bolt - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the 4 sliding roof drain hoses.





NOTICE:
The clip must face toward the outside of the vehicle and also be above the lower surface of the sliding roof housing when installing the drain hoses.

2. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY

(a) Using a T25 "TORX" socket wrench, temporarily install the sliding roof glass sub-assembly with the 4 screws.





(b) Perform a level check.





(1) Check the difference in level for "a" between the roof panel and the upper surface of the weather strip when the sliding roof glass is fully closed.

Standard:





HINT
"+" represents the condition that the glass is above the panel level. "-" represents the condition that the glass is below the panel level.

(c) Perform a gap check.





(1) Check the gap between the roof panel and roof glass.

NOTICE:
The gap must be even all around.

(d) After adjusting the sliding roof glass, using a T25 "TORX" socket wrench, install the sliding roof glass sub-assembly with the 4 screws.





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

3. CHECK FOR WATER LEAK

(a) After adjusting the sliding roof glass sub-assembly, check for water leaks.

(b) If there are any leaks, readjust the sliding roof glass sub-assembly.

4. INSTALL SLIDING ROOF SIDE GARNISH LH

(a) Engage the 5 claws and install the sliding roof side garnish LH.





5. INSTALL SLIDING ROOF SIDE GARNISH RH

HINT
Use the same procedure for the RH side and LH side.

6. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH Installation

7. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side.

8. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedure from Install Roof Headlining Assembly Installation.

9. RESET SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

Initialization

10. CHECK SLIDING ROOF SYSTEM

Operation Check

11. INSPECT FOR WATER LEAK

(a) After adjusting the sliding roof glass sub-assembly, inspect for water leaks.

(b) If there are any leaks, readjust the sliding roof glass sub-assembly.