Installation

LIGHTING (EXT): HEADLIGHT DIMMER SWITCH: INSTALLATION

1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY

(a) Using pliers, expand the clamp.

(b) While holding the clamp expanded, install the headlight dimmer switch assembly as shown in the illustration.

(e) Connect the connector.

2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Installation

3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation

4. INSTALL STEERING COLUMN COVER Installation

5. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

6. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation

7. INSTALL STEERING WHEEL ASSEMBLY Installation

8. INSPECT STEERING WHEEL CENTER POINT

9. INSTALL STEERING PAD Installation

10. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

11. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
* Make sure that the cable has been disconnected from the negative (-) battery terminal for at least 2 seconds before reconnecting the cable.
* Reset the auto tilt away function setting to the previous condition by changing the customize parameter Programming and Relearning.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

13. INSTALL REAR DECK FLOOR BOX Installation

14. INSPECT STEERING PAD Installation

15. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.