Front Fog Light Circuit

LIGHTING (EXT): LIGHTING SYSTEM: Front Fog Light Circuit
- Front Fog Light Circuit

DESCRIPTION

The main body ECU (multiplex network body ECU) controls the front fog light relay.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Active Test.

(e) Check that the relay operates.

Main Body





OK:

Front fog light relay operates. (Front fog lights come on.)

NG -- CHECK OPERATION (TAILLIGHTS)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Exterior Lighting System

2. CHECK OPERATION (TAILLIGHTS)

(a) Check the operation of the taillights.

OK:

Taillights operate normally.

NG -- GO TO PROBLEM SYMPTOMS TABLE Exterior Lighting System
OK -- Continue to next step.

3. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Remove the instrument panel junction block assembly.





(b) Connect a positive (+) lead from the battery to terminal 2K-1.

(c) Connect a negative (-) lead from the battery to terminals A-14 and A-13.

(d) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

OK -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Components