Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION

1. INSTALL OCCUPANT CLASSIFICATION ECU

(a) Install the occupant classification ECU with the claw.





NOTICE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.

(b) Engage the 3 claws to install the 2 connectors and wire harness holder.





Text in Illustration





(c) Install the 6 clamps.

(d) Connect the 4 connectors.

NOTICE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side Installation.

3. INSTALL REAR INNER SEAT TRACK BRACKET COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

5. INSTALL FRONT INNER SEAT TRACK BRACKET COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

6. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

7. INSTALL FRONT SEAT HEADREST ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side Installation.

8. INSPECT FRONT SEAT ASSEMBLY Installation

9. INSTALL REAR DECK FLOOR BOX Installation

10. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

11. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.