Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. PRECAUTION (w/ Air Suspension)

NOTICE:
Be sure to read Precaution thoroughly before servicing Service Precautions.

3. REMOVE REAR DECK FLOOR BOX Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE FRONT WHEEL

6. REMOVE FRONT SPEED SENSOR

(a) Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

HINT
Use the same procedure for the RH side and LH side.

(b) Remove the 5 clips and 3 screws, and turn back the front fender liner.

(d) Remove the bolt and No. 2 sensor clamp from the body.

Text in Illustration

(e) Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.

Text in Illustration

(f) Remove the bolt, resin clamp and front speed sensor.

Text in Illustration

NOTICE:
* Prevent foreign matter from attaching to the front speed sensor tip.
* Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.