Registration

SUSPENSION CONTROL: AIR SUSPENSION SYSTEM: REGISTRATION

1. REGISTRATION OF VEHICLE IDENTIFICATION INFORMATION

NOTICE:
* The CAN communication system must be functioning normally.
* Make sure that the power management control ECU is the correct type, normally functioning and correctly installed.

HINT
* If the suspension control ECU is replaced with a new one, perform registration of vehicle identification information.
* Vehicle identification information is obtained automatically through CAN communication when in test mode.

(a) Turn the power switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch on (IG).

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / Air suspension / Utility / Signal Check.

(f) Confirm that the system is in test mode by checking that the luggage mode indicator light in the combination meter blinks at 0.125 second intervals (0.125 seconds on and 0.125 seconds off).





HINT
* When the vehicle identification information is stored, the luggage mode indicator light blinks at 0.125 second intervals (0.125 seconds on and 0.125 seconds off).
* When vehicle identification information is not stored, the luggage mode indicator light blinks at 1 second intervals (1 second on and 1 second off).