Installation

LIGHTING (EXT): HAZARD WARNING SWITCH: INSTALLATION

1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Engage the 2 claws and install the hazard warning signal switch assembly.





(b) Engage the 2 clamps.

2. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER Installation

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

4. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

6. INSTALL NO. 1 SWITCH HOLE BASE Installation

7. INSTALL INSTRUMENT PANEL GARNISH LH Installation

8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Air Suspension)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

11. INSTALL REAR DECK FLOOR BOX (w/ Air Suspension) Installation

12. INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

(a) Inspect the suspension control system Test Mode Procedure.