Wiper & Washer Switch

1. Inspect switch continuity as follows:
a. Remove switch as described under COMBINATION SWITCH.

Fig. 20 Wiper & Washer Switch Continuity Test Chart:

b. Test continuity following the chart in Fig. 20. If continuity is not as specified, replace switch.

Fig. 21 Wiper & Washer Switch Resistance Test Chart:

2. Inspect switch resistance by following Fig. 21. If resistance is not as specified, replace switch.
3. Inspect switch circuit as follows:
a. Disconnect switch and relay connectors.

Fig. 22 Wiper & Washer Switch Circuit Test Chart:

b. Follow the chart in Fig. 22 and inspect wiring on wiring harness side of the connectors.
c. If circuit is not as specified, inspect other portions of the circuit.