Inspection

COMBINATION METER ASSEMBLY INSPECTION
1. INSPECT COMBINATION METER WIRING CIRCUIT
Disconnect connector "A". connector "B" and connector "C" from the combination meter and inspect the connectors on the wire harness side as follows.





















If circuit is not as specified, refer to wiring diagram and inspect the circuit connected to other parts.
2. INSPECT VEHICLE SPEED SIGNAL
(a) Remove the combination meter with connector connected.
(b) Connect the positive (+) lead from the tester to terminal B13 and the negative (-) lead to terminal B15.
(c) Shift the shift lever to N position.
(d) Jack up the front wheel on one side.
(e) Turn ignition switch on.
(f) Revolve the wheel.
(g) Check that there is voltage between terminals B13 and B15 changes from approx. 0 V to 12 V.
If operation is not as specified, inspect speed sensor or wire harness.