Air Flow Meter/Sensor: Service and Repair

Air Cleaner Hose:

Removal

1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY

CAUTION (W / Airbag): Work must be started after approx. 30 seconds or longer from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable disconnected from the battery.

2. DISCONNECT COIL CORD CLAMP

3. DISCONNECT VOLUME AIR FLOW METER CONNECTOR

4. DISCONNECT AIR CLEANER HOSE

5. REMOVE AIR CLEANER CAP AND VOLUME AIR FLOW METER ASSEMBLY

Air Flow Meter:

6. REMOVE VOLUME AIR FLOW METER FROM AIR CLEANER CAP

(a) Remove the screw and wire bracket.

(b) Remove the bolt, two screws and bracket.

Lock Plate:

(c) Pry off the lock plate, and remove the four nuts, lock plate, volume air flow meter and gasket.


Installation
1. INSTALL VOLUME AIR FLOW METER TO AIR CLEANER CAP

(a) Install the volume air flow meter with the gasket, lock plate, four plate washers, four nuts and bolt. Pry the lock plate on the nut.



(b) Install the bracket with the bolt and two screws.

(c) Install the wire bracket with the screw.



2. INSTALL AIR CLEANER CAP AND VOLUME AIR FLOW METER ASSEMBLY



3. CONNECT AIR CLEANER HOSE

4. CONNECT VOLUME AIR FLOW METER CONNECTOR

5. CONNECT COIL CORD CLAMP

6. CONNECT CABLE TO NEGATIVE TERMINAL OF BATTERY