Mudguard - Installation Instructions

BULLETIN NUMBER:
AX92-001

SECTION:
ACCESSORIES

DATE:
JULY 3, 1992

TITLE:
ES300 MUDGUARD INSTALLATION INSTRUCTIONS

MODELS:
ES300

A mudguard kit is now available for installation on 1992 ES300's. Be sure to thoroughly clean all attachment areas and carefully follow the installation procedures below.

INSTALLATION PROCEDURE:

FRONT OF VEHICLE

Figure 1:

1. Take out screws 1 and 2 which secure the front fender liner. (see Figure 1)

Figure 2:

2. Insert the round flanged grommet (supplied in the kit) into hole, at point A, at bottom of fender well. (see Figure 2)

Figure 3:

3. Re-using screws 1 and 2, install the mudguard at points 1 and 2, while holding the mudguard against body to insure proper fit and tighten down screws. (see Figure 3)

Figure 4:

4. Using two screws (supplied in the kit), install the mudguard at points 3 and 4.

NOTE: There are no holes in plastic cladding at points 3 and 4, so please use mudguard as a template to locate proper location of holes and apply pressure firmly on the self-tapping screws to pierce cladding and tighten screws. (see Figure 4)

Figure 5:

5. Using a screw and washer (supplied in the kit), install the mudguard at point A and tighten down screws. (see Figure 5)

REAR OF VEHICLE

Figure 6:

1. Remove bolt B, found at lower body panel to fender well attachment intersection. (see Figure 6)

Figure 7:

2. Re-using bolt B, install the attachment adaptor bracket at point B. (see Figures 6 and 7)

Figure 8:

3. Insert the square flanged grommet (supplied in the kit), at point C, at bottom of fender well. (see Figure 8)

Figure 9:

Figure 10:

4. Using three screws (supplied in the kit), install the mudguard at points 5, 6, 7 and 8 while holding mudguard against body to insure proper fit and tighten down screws. (see Figures 9 and 10)

Figure 11:

5. Using a screw (supplied in the kit), install the mudguard at point C and tighten down. (see Figure 11)





PART NUMBER INFORMATION