Lamp Out Indicator: Testing and Inspection

Light Failure Sensor
REMOVAL AND INSTALLATION OF LIGHT FAILURE SENSOR
1. REMOVE LIGHT FAILURE SENSOR
(a) Remove luggage front trim cover.
(b) Remove a nut and disconnect connector.
(c) Remove light failure sensor.
2. INSTALL LIGHT FAILURE SENSOR
For installation, follow the removal procedure in reverse.


INSPECTION OF LIGHT FAILURE SENSOR
INSPECT LIGHT FAILURE SENSOR

(Relay Circuit)






Disconnect the connector from the sensor and inspect the connector on the wire harness side as shown.






If circuit is as specified, replace the sensor.