Preliminary Check

1. CHECK FLUID LEVEL

HINT:
- Drive the vehicle so that the engine and transmission are at normal operating temperature. Fluid temperature: 70 - 80°C (158 - 176°F)
- Only use the COOL range on the dipstick as a rough reference when the fluid is replaced or the engine does not run.





- Park the vehicle on a level surface and set the parking brake.
- With the engine idling and the brake pedal depressed, shift the shift lever into all positions from the P to the L position and return to the P position.
- Pull out the dipstick and wipe it clean.
- Push it back fully into the pipe.
- Pull it out and check that the fluid level is in the HOT range.
- If the level is at the low side, add fluid. Fluid type: ATF TYPE T- II or equivalent

NOTICE: Do not overfill.

2. CHECK FLUID CONDITION
- If the fluid smells burnt or is black, replace it.





3. REPLACE TRANSMISSION FLUID
- Remove the drain plug and drain the fluid.
- Reinstall the drain plug securely.
- With the engine OFF, add new fluid through the oil filler pipe.

Fluid type: ATF TYPE T- II or equivalent

Capacity:
Drain and refill: 1.9 liters (2.0 US qts, 1.7 Imp.qts)





- Start the engine and shift the shift lever into all positions from the P to the L position and then shift into the P position.
- With the engine idling, check the fluid level.
- Add fluid up to the COOL level on the dipstick.





- Check the fluid level at the normal operating temperature, 70 - 80°C (158 - 176°F), and add if necessary.

NOTICE: Do not overfill.

4. CHECK FLUID LEAKS
- Check for leaks in the transmission.
- If there are leaks, it is necessary to replace O-rings, FIPG, oil seals. plugs or other parts.





5. INSPECT AND ADJUST THROTTLE CABLE
- Check that the throttle valve is fully closed.
- Check that the inner cable is not slack.
- Measure the distance between the outer cable end and stopper on the cable.

Standard distance: 0 - 1 mm (0 - 0.04 in.)

- If the distance is not the standard, adjust the cable by the adjusting nuts.




6. INSPECT AND ADJUST SHIFT LEVER POSITION
- When shifting the shift lever from the N position to other positions, check that the lever can be shifted smoothly and accurately to each position and that the position indicator correctly indicates the position.
- If the indicator is not aligned with the correct position. carry out the following adjustment procedures.
- Loosen the nut on the shift lever subassembly.
- Push the control shaft lever fully rearward.
- Return the control shaft lever 2 notches to the N position.
- Set the shift lever to the N position.





- While holding the shift lever lightly toward the R position side, tighten the nut.

Torque: 13 N.m (130 kgf.cm, 9 ft.lb.)

- Start the engine and make sure that the vehicle moves forward when shifting the lever from the N to D position and reverses when shifting it to the R position.





7. INSPECT AND ADJUST PARK/NEUTRAL POSITION SWITCH
- Check that the engine can be started with the shift lever only in the N or P position, but not in other positions.
- If not as started above. carry out the following adjustment procedure.
- Loosen the park/neutral position switch bolt and set the shift lever to the N position.
- Align the groove and neutral basic line.
- Hold in position and tighten the bolt.

Torque: 13 N.m (130 kgf.cm, 9 ft.lb.)

- For continuity inspect of the park/neutral position switch.
8. INSPECT IDLE SPEED

Idle speed: 700 - 50 rpm (In the N position and A/C OFF)