Disconnection and Connection of Bolt Type Connectors

Disconnection And Connection Of Bolt Type Connectors:

For Engine Control Module (Engine And Electronic Controlled Transmission ECU) in this vehicle, connectors are used which require a bolt built into the connector to be screwed down to securely connect the connector.


1. Disconnect the connector
After completely loosening the bolt, the two parts of the connector can be separated.

NOTICE:
Do not pull the wire harness when disconnecting the connector.


2. Connect the connector


NOTICE:
Before connecting the connector, always check that the terminals are not bent or damaged.

a. Match the guide section of the male connector correctly with the female connector, then press them together.

b. Tighten the bolt.
Make sure the connectors are completely connected, by tightening the bolt until there is a clearance of less than 1 mm (0.04 in.) between the bottom of male connector and the end of female connector.