GS 300
GS 3001. Removal of parts.
a. Remove the undercover.
NOTE:
Pull down the dip areas (3 places) of the Undercover to remove.
b. Remove the lamp.
c. Remove the (2) wing nuts and the plate on the bottom of the cooling unit.
CAUTION:
The plate and wing nuts will be reused.
d. Remove the (2) filters from the cooling unit.
2. Clean the Evaporator.
- Follow the general procedures.
NOTE:
Location for insertion of spray nozzle is indicated by the red arrow in the illustration.
3. Reinstallation of parts.
a. Insert the (2) filters into the cooling unit as shown in the illustration.
NOTE:
Insert a dean air filter with it's knob facing downwards, then slide it forward and install the second filter in the same manner.
b. Assemble the rubber insulator on the plate.
CAUTION:
To prevent the cooling unit from leaking water; pull the three rubber projections from the other side of the plate to make sure that the rubber insulator seals properly against the plate.
c. Install the plate on the cooling unit and secure with the (2) wing nuts.
CAUTION:
To prevent water leaks, verify that the cooling unit and plate are fully secure before tightening the wing nuts.
NOTE:
Before installing the plate on the cooling unit, coat the rubber insulator with water for easier assembly.
d. Reinstall the lamp.
e. Reassemble the Undercover.