Removal and Installation
1. Remove propeller shaft, then drain differential oil, Fig. 20.Fig. 20 Differential Carrier Replacement:
2. Place alignment marks on driveshafts and differential, then using axle bolt removal tool No. 09043-38100, or equivalent, remove driveshafts from differential and support with wire.
3. Support differential with jack, then remove three mounting cushion bolts from rear of differential.
4. Remove two side mounts and differential.
5. Reverse procedure to install, noting the following:
a. Torque side support bolts to 90 ft. lb.
b. Torque rear support bolts to 105 ft. lb.
c. Torque driveshafts to 61 ft. lb.
d. Fill differential with suitable lubricant.