Overhaul
DISASSEMBLYNo.2 Lower Suspension Arm
1. Loosen the two lock nuts.
2. Turn and disassemble the No.2 lower suspension arm.
3. Remove the lock nuts from the No.2 lower suspension arm.
ASSEMBLY
No.2 Lower Suspension Arm
1. Install the two lock nuts to the No.2 lower suspension arm.
2. Turn the adjusting tube and assemble the No.2 lower suspension arm.
NOTE: When assembling the No.2 lower suspension arm, try to make dimensions A and B shown in the illustration as close as possible. The maximum difference is 3.0 mm (0.118 inch).
3. Adjust the No.2 lower suspension arm length by turning the adjusting tube. The arm length should be 512.3 mm (20.169 inch).
4. Temporarily tighten the two lock nuts.
NOTE: After adjusting the rear wheel alignment, tighten the lock nuts to 56 Nm (41 ft. lbs.).