Component Inspection

INSPECT DOOR OUTSIDE HANDLE SWITCH CONTINUITY
a. Check that there is continuity between terminals 1 and 2 when door outside handle is pulled.
b. Check that there is no continuity between terminals 1 and 2 when door outside handle is released.
If operation is not as specified, replace the switch.




INSPECT COURTESY SWITCH CONTINUITY
a. Connect the connector to the driver door ECU.
b. Check that there is continuity between terminals 3 and 6 when door is opened.
c. Check that there is no continuity between terminals 3 and 6 when door is closed.
If continuity is not as specified, replace the switch.
If continuity is as specified, inspect the switch circuit.

INSPECT COURTESY SWITCH CIRCUIT







INSPECT FRONT PERSONAL LIGHT SWITCH CONTINUITY
If continuity is not as specified, replace the light assembly or bulb.

INSPECT FRONT PERSONAL LIGHT SWITCH CIRCUIT







Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the power source or wire harness.







INSPECT REAR PERSONAL LIGHT ASSEMBLY CONTINUITY
Rear room light:
If continuity is not as specified, replace bulb or rear personal light assembly.

INSPECT REAR PERSONAL LIGHT ASSEMBLY CONTINUITY
Rear door courtesy light:




Using the ohmmeter check that there is continuity between terminals.
If continuity is not as specified, replace the bulb or rear person
light assembly.

INSPECT REAR PERSONAL LIGHT ASSEMBLY CIRCUIT
Rear room light:







Disconnect the connector from the light and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the power source or wire harness.

INSPECT REAR PERSONAL LIGHT ASSEMBLY CIRCUIT
Rear door courtesy light:







Disconnect the connector from the light and inspect the connector on the wire harness, as shown.
If circuit is not as specified, inspect the power source or wire harness.

INSPECT DOOR COURTESY LIGHT CONTINUITY




Using the ohmmeter, check that there is continuity between terminals.
If continuity is not as specified, replace the light assembly or bulb.