Removal and Installation

COMPONENTS

REMOVAL




1. REMOVE BATTERY CLAMP COVER
2. REMOVE AIR CLEANER INLET
3. REMOVE GENERATOR DRIVE BELT
Loosen the belt tension by turning the belt tensioner counterclockwise, and remove the drive belt.

HINT: The pulley bolt for the belt tensioner has a left - hand thread.




4. REMOVE OIL PAN PROTECTOR
5. REMOVE ENGINE UNDER COVER
6. DISCONNECT PS OIL COOLER PIPE FROM OIL PAN
7. REMOVE PS PUMP
8. REMOVE GENERATOR
a. Disconnect the generator connector.
b. Remove the rubber cap and nut, and disconnect the generator wire.
c. Disconnect the generator wire clamp from the cord clip on the generator.
d. Disconnect the heated oxygen sensor wire clamp from the cord clip on the generator.
e. Remove the bolt, nut and generator.

INSTALLATION




1. INSTALL GENERATOR
a. install the generator with the bolt and nut.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
b. Connect the generator connector.
c. Connect the generator wire with the nut and rubber cap
d. Install the generator wire clamp to the cord clip on the generator.
e. Install the heated oxygen sensor wire clamp to the cord clip on the generator.




2. INSTALL PS PUMP
3. INSTALL PS OIL COOLER PIPE
4. INSTALL GENERATOR DRIVE BELT
Install the belt by turning the belt tensioner counterclockwise.

HINT: The pulley bolt for the belt tensioner has a left - hand thread.

5. PERFORM ON-VEHICLE INSPECTION
6. INSTALL ENGINE UNDER COVER
7. INSTALL OIL PAN PROTECTOR
8. INSTALL AIR CLEANER INLET
9. INSTALL BATTERY CLAMP COVER