Radiator Cooling Fan: Service and Repair
BLEEDING1. REMOVE V-BANK COVER
2. CHECK FLUID LEVEL IN RESERVOIR TANK
If low, add fluid.
Fluid: ATF DEXRON II
HINT: Check that fluid level is within the "HOT" level on reservoir tank. If the fluid is cold, check that it is with in the "COLD" level on the reservoir tank.
3. BLEED COOLING SYSTEM
a. Using Special Service Tool (SST), connect terminals OP1 and E1 of the DLC1.
SST 09843-18020
HINT: When terminals OP1 and E1 are connected, the circuit of the ECT sensor is grounded, fixing the cooling fan speed at approx. 1,100 rpm. (Fail-safe operation occurs.)
b. Start the engine without depressing the accelerator pedal.
c. Leave the engine running for several seconds.
d. Check that there is no foaming and emulsification of the fluid in the reservoir tank.
e. Remove the SST from the DLC1
SST 09843-18020
4. REINSTALL V-BANK COVER