Removal and Installation

REMOVAL
1. REMOVE FRONT WHEEL
2. REMOVE THESE PARTS:
a. Clip and 2 pins
b. Anti-rattle spring
c. 2 pads with anti-squeal shims and spacers

HINT: Do not disconnect the pad wear indicator unless you are replacing the brake pads.





3. DISCONNECT BRAKE HOSE
a. Remove the union bolt and gasket from the caliper, then disconnect the brake hose from the caliper.
Torque: 39 Nm (400 kgf.cm, 29 ft. lbs.)

HINT: At the time of installation, please refer to the following item. Install the flexible hose lock securely in the lock hole in the caliper.

b. Use a container to catch the brake fluid as it drains out.





4. REMOVE CALIPER
Remove the 2 bolts and caliper from the knuckle.
Torque: 118 Nm (11,200 kgf.cm, 87 ft. lbs.)

INSTALLATION
Installation is in the reverse order of removal.
1. AFTER INSTALLATION, FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
2. CHECK FOR FLUID LEAKAGE