Camshaft Position Sensor: Service and Repair

COMPONENTS

REMOVAL
1. REMOVE V-BANK COVER

2. REMOVE BATTERY CLAMP COVER
3. REMOVE AIR CLEANER INLET
4. DRAIN ENGINE COOLANT
5. DISCONNECT RADIATOR HOSE
6. REMOVE NO.3 TIMING BELT COVER
7. DISCONNECT CAMSHAFT POSITION SENSOR CONNECTOR
8. REMOVE CAMSHAFT POSITION SENSOR
Remove the bolt, stud bolt and camshaft position sensor.

INSTALLATION




1.INSTALL CAMSHAFT POSITION SENSOR
Torque: 7.5 N.m (80 kgf.cm, 66 in.lbf)
2. CONNECT CAMSHAFT POSITION SENSOR CONNECTOR
3. INSTALL NO.3 TIMING BELT COVER
4. CONNECT RADIATOR HOSE
5. INSTALL AIR CLEANER INLET
6. INSTALL BATTERY CLAMP COVER
7. INSTALL V-BANK COVER
8. FILL ENGINE COOLANT
9. CHECK ENGINE COOLANT FOR LEAKS
10. CHECK IGNITION TIMING