Mirrors: Service and Repair

REMOVAL




1. REMOVE DOOR INSIDE HANDLE BEZEL
a. Open the cap, then remove the screw.
b. Using a screwdriver, remove the inside handle bezel.

HINT: Tape the screwdriver tip before use.

2. REMOVE UPPER BRACKET GARNISH
3. REMOVE POWER WINDOW SWITCH




4. REMOVE DOOR TRIM
a. Using a screwdriver, remove the screw cap.

HINT: Tape the screwdriver tip before use.

b. Remove the 2 screws.
c. Insert a screwdriver between the door panel and door trim to pry the trim out.

HINT: Tape the screwdriver tip before use.

d. Pull the trim upward to remove it, then disconnect the courtesy light connector.

5. REMOVE TWEETER SPEAKER
Remove the nut and tweeter speaker.

6. REMOVE OUTSIDE REAR VIEW MIRROR
a. Disconnect the connector.
b. Remove the 3 nuts and outside rear view mirror.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

REPLACEMENT




1. IF NECESSARY, DISCONNECT MIRROR
a. Insert a shop rag between the mirror and mirror body to wrap up the mirror in the shop rag.
b. Pull up the lower side of the shop rag to disconnect the mirror joint.




c. Pull up the mirror and disconnect it.




d. Disconnect the connector.




2. CONNECT MIRROR
a. Engage the claws (A) and set the mirror to the mirror body.
b. Push the mirror to engage the claws (B) and connect it.

INSTALLATION
Installation is in the reverse order of removal.