Rear Door: Service and Repair
DISASSEMBLY1. REMOVE THESE PARTS:
a. Door inside handle bezel
b. Armrest base panel
c. Rear door courtesy light
2. REMOVE DOOR TRIM
a. Remove the 4 screws.
b. Insert a screwdriver between the panel and the trim and remove the clips.
NOTE: Do not scratch the panel with the screwdriver.
HINT: Tape the screwdriver tip before use.
c. Remove the trim by pulling all of the trim up.
d. Remove the 2 cables from the door inside handle.
3. REMOVE THESE PARTS:
a. Rear door speaker
b. Rear door frame garnish
c. Inside handle
d. Rear door ECU
4. REMOVE REAR DOOR INNER WEATHERSTRIP
Using a scraper, remove the inner weatherstrip.
HINT: Tape the scraper tip before use.
5. REMOVE SERVICE HOLE COVER
6. REMOVE REAR DOOR GLASS RUN
7. REMOVE DOOR GLASS
Remove the 2 nuts and the door glass.
8. REMOVE DIVISION BAR
a. Remove the 2 bolts and screw.
b. Remove the division bar.
9. REMOVE REAR DOOR QUARTER WINDOW GLASS
10. REMOVE WINDOW REGULATOR
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
HINT: At the time of reassembly, please refer to the following item.
Apply adhesive MP grease to window rollers.
11. REMOVE DOOR LOCK
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
HINT: At the time of reassembly, please refer to the following item.
Apply adhesive to the screw.
Part No. 08833-00070 THREE BOND 1324 or equivalent
12. REMOVE THESE PARTS:
a. Rear door outside handle
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
b. Child protector lock lever knob
c. Rear door inside handle
d. Ornament
e. Panel
f. Power window switch
REASSEMBLY
Reassembly is in the reverse order of disassembly
For Power Window Initialization/Reset