Headliner: Service and Repair
REMOVAL1. REMOVE MAP LAMP ASSEMBLY
a. Using a screwdriver, remove the lens and cover.
HINT: Tape the screwdriver tip before use.
b. Remove the 4 screws and map lamp assembly.
c. Disconnect the connectors.
2. REMOVE THESE PARTS:
a. Rear seat
b. Sun visors and holders
c. Assist grips
d. Front door inside scuff plates
e. Rear door inside scuff plates
f. Front door opening trims
g. Rear door opening trims
h. Front pillar garnishes
i. Rear personal lights
j. Rear seat side garnishes
3. REMOVE CENTER PILLAR LOWER GARNISHES
Using a screwdriver, remove the center pillar lower garnish.
HINT:
- Tape the screwdriver tip before use.
- Do the same for LH and RH.
4. REMOVE CENTER PILLAR UPPER GARNISHES
HINT:
- Tape the screwdriver tip before use.
- Do the same for LH and RH.
a. Remove the 2 screws.
b. Using the screwdriver, remove the center pillar upper garnish.
5. REMOVE ROOF SIDE INNER GARNISHES
Using a screwdriver, remove the roof side inner garnishes.
HINT: Tape the screwdriver tip before use.
6. REMOVE ROOF HEADLINING
a. w/ Sliding Roof:
Remove the opening trim.
b. Release the 3 clips and fastener tapes to remove the roof headlining.
INSTALLATION
1. INSTALL ROOF HEADLINING
a. Slide the roof headlining rearward to connect the hook to the body.
b. Fasten the fastener tape and install the 3 clips to the body.
2. INSTALL ROOF SIDE INNER GARNISHES
Install the roof side inner garnishes to the body.
3. INSTALL CENTER PILLAR UPPER GARNISHES
Install center pillar upper garnishes with the 4 screws.
4. INSTALL CENTER PILLAR LOWER GARNISHES
Install the center pillar lower garnishes to the body.
5. INSTALL THESE PARTS:
a. Rear seat side garnishes
b. Rear personal lights
c. Front pillar garnishes
d. Rear door opening trims
e. Front door opening trims
f. Rear door inside scuff plates
g. Front door inside scuff plates
h. Assist grips
i. Sun visors and holders
j. Rear seat
6. INSTALL MAP LAMP ASSEMBLY
a. Connect the connector.
b. Install the map lamp assembly with the 4 screws.
c. Install the lens and cover.