Rear Door: Adjustments
ADJUSTMENT1. ADJUST REAR DOOR
a. Remove these parts:
1. Front door scuff plate
2. Rear door scuff plate
3. Center pillar garnish
4. Front seat belt retractor bolts
b. Adjust the rear door in forward/rearward and vertical directions.
Loosen the body side nuts to adjust.
Torque: 33 N.m (330 kgf.cm, 24 ft.lbf)
c. Adjust rear door in left/right and vertical directions. Loosen the door side hinge bolts to adjust.
Torque: 26 N.m (260 kgf.cm, 19 ft.lbf)
d. Adjust the rear door lock striker.
Adjust the rear striker in the same manner as the front door.
2. ADJUST DOOR GLASS
Adjust the door glass.
HINT: Check that there is space between the glass guide and stopper.
1. Fully raise the glass, and adjust the gap between the glass and door panel.
2. After adjustment, immobilize the guide, stoppers and 2 nuts.
HINT:
- Check that the edge of the glass does not come in contact with the bottom part of the weatherstrip when the glass is being raised or lowered.
- Check that the glass moves up and down smoothly and that the weatherstrip does not get caught by the glass.
3. Raise the glass again and check the installation.