Solar Sensor: Service and Repair

1. REMOVE SOLAR SENSOR
Using a screwdriver, pull out the sensor then disconnect the connector.






HINT:
- Tape the screwdriver tip before use.
- At the time of installation, please refer to the following item.

Install the sensor, as shown in the illustration.




2. REMOVE ROOM TEMPERATURE SENSOR
a. Remove the No.1 safety pad set bolts.
b. Disconnect No.1 safety pad.
c. Disconnect the connector and aspirator hose.
d. Remove the screw and sensor.




3. REMOVE AMBIENT TEMPERATURE SENSOR
a. Disconnect the connector.
b. Pull out the sensor.

4. REMOVE EVAPORATOR TEMPERATURE SENSOR
a. Remove the evaporator




b. Remove the sensor.
c. Pull out the sensor from evaporator.

5. REMOVE DUCT SENSOR
a. Remove the instrument panel




b. Remove the sensors.
1. Disconnect the connector.
2. Remove driver side sensor from the No.3 heater to resistor duct.
3. Remove passenger side sensor from the No.1 heater to resistor duct.




6. REMOVE SMOG VENTILATION SENSOR
a. Disconnect the connector.
b. Remove the bolt and sensor.