Torque Specifications

Part 1 of 10





Part 2 of 10





Part 3 of 10





Part 4 of 10





Part 5 of 10





Part 6 of 10





Part 7 of 10





Part 8 of 10





Part 9 of 10





Part 10 of 10





Cylinder Head Bolt Tightening Sequence
Using the sequence shown and in several passes, install and uniformly tighten the 10 cylinder head bolts with plate washers to 39 Nm (29 ft. lbs.) on one cylinder head in, then repeat on the other side.





Mark the front of the cylinder head bolt head with paint.
Retighten the cylinder head bolts by 90° in the numerical order shown.
Check that the painted mark is now at a 90° angle to front.







LH Camshaft Bearing Cap Bolts Tightening Sequence





RH Camshaft Bearing Cap Bolts Tightening Sequence





Head Bolt Reuse/Replace
Standard outside diameter: 9.770-9.960 mm (0.3846-0.3921 inch).
Minimum outside diameter: 9.600 mm (0.3780 inch)
If the diameter is less than minimum, replace the bolt.