Mirrors: Service and Repair

REMOVAL




1. REMOVE DOOR INSIDE HANDLE BEZEL COVER
Using a screwdriver, pry upward the door inside handle bezel cover.

HINT: Tape the screwdriver tip before use.




2. REMOVE DOOR TRIM
a. Remove the 8 screws.
b. Using a screwdriver, remove the door trim by pulling the whole trim up.

HINT: Tape the screwdriver tip before use.




c. Remove the 2 cables from the door inside handle.
d. Disconnect the connector.




3. REMOVE DOOR FRAME GARNISH
Remove the nut and door frame garnish.

4. REMOVE TWEETER SPEAKER
Disconnect the connector and remove the tweeter speaker.

5. REMOVE OUTSIDE REAR VIEW MIRROR
Disconnect the connector, then remove the 3 bolts and outside rear view mirror.

REPLACEMENT




1. IF NECESSARY, DISCONNECT MIRROR
a. Insert a shop rag between the mirror and the mirror body.
b. Pull up the lower side of the shop rag to disconnect the mirror joint.




c. Pull up the mirror and disconnect it.




d. Disconnect the connectors.




2. CONNECT MIRROR
a. Connect the connectors.
b. Connect the claws (A) and set the mirror to the mirror body.
c. Push the mirror to connect the claws (B) and set it.

INSTALLATION

1. INSTALL OUTSIDE REAR VIEW MIRROR
Install the outside rear view mirror with the 3 bolts, then connect the connector.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)




2. INSTALL TWEETER SPEAKER
a. Connect the claw and set the tweeter speaker to the door.
b. Connect the connector.

3. INSTALL DOOR FRAME GARNISH
Install the door frame garnish with the nut.




4. INSTALL DOOR TRIM
a. Connect the connectors.
b. Install the 2 cables to the door inside handle.




c. Install the door trim with the 8 screws.

5. INSTALL DOOR INSIDE HANDLE BEZEL COVER