Removal and Installation

REMOVAL
1. REMOVE REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)





2. DISCONNECT FLEXIBLE HOSE
Remove the union bolt and gasket from the caliper, then disconnect the flexible hose from the caliper. Use a container to catch brake fluid as it drains out.
Torque: 30 Nm (310 kgf-cm, 22 ft. lbs.)

HINT: At the time of installation, please refer to the following item. Install the flexible hose lock securely in the lock hole in the caliper.

3. REMOVE CALIPER
a) Remove the 2 installation bolts.
Torque: 104 Nm (1,065 kgf-cm, 77 ft. lbs.)
b) Remove the caliper.
4. REMOVE BRAKE PADS
a) Remove the anti-squeal spring.
b) Remove the clip and pad guide pin.
c) Remove the 2 pads with the 4 anti-squeal shims.

INSTALLATION
Installation is in the reverse order of removal.

HINT:
^ After installation, fill the brake reservoir with brake fluid and bleed brake system.
^ Check for leaks.